18W LED T8 Tube with UL CE Listed, 4ft/1200mm, single-ended input voltage AC90-2... > LED Tube Light > Product > Home
All Products
News

How much do you know these decorate choose lamp myth?
How much do you know these decorate choose lamp myth? LED lighting products quality inspection&...

LED High Bay Fixture is certified for hazardous locations.
LED High Bay Fixture is certified for hazardous locations.

The heat of LED products and the heat dissipation of LED
In the days that advocates energy-saving and environmental friendly, LED will be the most promising ...

Contact Us

Gidealed Lighting Co.,Ltd 

Tel:0086-750-2098318   

Phone:0086-13826159758

Email:sales@gidealed.com

Postcode:529080
Add:No.1 Minhui Rd,Gaoxin Developement District,JiangMen,

Guangdou,China

        


18W LED T8 Tube with UL CE Listed, 4ft/1200mm, single-ended input voltage AC90-260V

Item No.:GD-T8W120-20,18W LED T8 Tube with UL CE Listed
Detailed Product Description

18W 4ft/1200mm LED T8 Tube with UL CE Listed

18w 4ft led tube UL Listed LED Lights with rotatable end caps design

Non-Isolated LED driver with conversion efficiency over 0.86

Inside buckled frosted PC cover of 0.85-0.88 light emitting rate

Anodic oxidation technique to protect aluminum housing surface

International Standard lamp accessories: connectors, clips, screws, etc.

Application:

T8 LED Tube is new indoor lighting product. With special circuit design and heat dissipation, the T8 LED Tube Light can achieve high luminous efficacy, energy saving, long lifespan, high lumens, no flickering and high CRI. Applied with new type of LED, the tube has the same or even more light output compared with fluorescent tube without reflector or flick when starting. For example, our 9W, 18W, 22W T8 led tube light fixtures can replace 20W,40W and 60W traditional fluorescent tubes and do not need ballast or starter.

Specification:


Aging Test:


LED Tube Installation

LED Tube Light Wiring Diagram:


Installation Instructions
1)Turn off the electricity supply before installation .
2)For refitting old fluorescent lamp with a single-side-power-input LED tube, please re-connect your wire as the following diagram.


3)For diagram A1 loop with magnetic ballast & starter, please remove the starter first. Then connect line N and Line L to the same side socket but separately. Now you can put on the LED tube and turn it on. And the loop has been changed into the one as showed in diagram A2.


Note: You can just keep magnetic ballast as it was. However, it’ll consumer some power. For saving energy, it’s still suggested to remove it if your labor cost is not so high.

4) For diagram B1 loop with electronic ballast, please remove the electronic ballast first. Then connect line N and Line L to the same side socket but separately. Now your LED tube light is ready to work. And the loop has been changed into what showed in diagram B2.



Gidealed Lighting Co.,Ltd 

Tel:0086-750-2098318   

Phone:0086-13826159758

Email:sales@gidealed.com

Postcode:529080
Add:No.1 Minhui Rd,Gaoxin Developement District,JiangMen,

Guangdou,China

        


Send your inquiry directly to us

(0 / 3000)